Home> Retail>  Veneer Facing Application

Veneer Facing Instructions - Prepare Surface

Peel 'N Stick

  • Surface must be smooth, clean, dry & free of oil or dust. A sealed surface is recommended.
  • Fill holes and sand smooth
  • Remove dust and oil residue
  • Cut facing to allow for a 1/2" overlap on all sides

Iron-on & Paper-backed

  • Surface must be clean and dry
  • Fill holes and sand smooth
  • Remove sawdust
  • Cut facing to allow for 1/2" overlap on all sides
 

Veneer Facing Instructions - Apply Facing

Peel 'N Stick

  • Peel release paper back approxmately 1/4" along longest edge
  • Position and press lightly into place
  • Gradually remove remaining release paper with one hand, while pressing facing into place with other hand, as shown

Iron-on

  • Preheat iron to Cotton setting [400ºF]
  • Position facing
  • Use kraft paper or aluminum foil to protect iron bottom
  • Slowly move iron over veneer to activate adhesive
  • Check to see if glue is melting

Paper-backed

  • Apply contact cement to both surfaces
  • Allow both surfaces to dry thoroughly
  • Cover prepared surface with waxed paper
  • Position veneer on surface over waxed paper
  • While holding veneer in place, slowly slide waxed paper out
  • Continue until waxed paper is removed
RetailApplyVenrFacV4_12.gif RetailApplyVenrFacV4_13.jpg RetailApplyVenrFacV4_14.jpg

Veneer Facing Instructions - BondingIron-on

  • While still hot, press facing down firmly with a rolling pin, roller or non-metallic blade, following the direction of the grain, to remove any air bubbles
  • Mistake? Simply reheat and reapply

Peel 'N Stick & Paper-backed

  • Press facing down firmly using a rolling pin, roller or non-metallic blade, following the direction of the grain, to remove air bubbles
  RetailApplyVenrFacV4_17.jpg

Veneer Facing Instructions - Trim and Finish Iron-on

  • Allow facing to cool completely
  • Trim edge flush with a router, a utility knife or file
  • If needed, sand lightly with fine sandpaper
  • Sparingly apply each coat of stain or finish with a soft, lint-free cloth

Peel 'N Stick & Paper-backed

  • Allow facing to set a least 30 minutes before trimming
  • Trim edge flush with a router, a utility knife or file
  • If needed, sand lightly with fine sandpaper
  • Sparingly apply each coat of stain or finish with a soft, lint-free cloth
  RetailApplyVenrFacV4_21.jpg
Create, Decorate Renew or Repair

Antiques
Appliances
Basement Poles
Bay window seats
Benches
Bookcases
Cabinets
Closet Organizers
Compactors
Crafts
Create new furniture
Dashboards

Decorative Boxes
Desks
Dishwashers
Doll Houses
Doors & Frames
Dressers
Entertainment Centers
Exposed Beams
Faux Paneling
File Cabinets
Frames (simple)
Freezers

Gifts & Crafts
Hand Rails & Caps
Head Boards
Hobbies
Home Decorating
Kitchen Cabinets
Inlays
Laundry rooms
Mantles
Marquetry
Metal Doors
New Furniture

 
 

Mantles
Pianos
Recipe boxes
Refrigerators
Scrapbooking
Shelving
Storage Chests
Table Tops
Toy boxes
Upgrade trailer moldings
Window Seats and more!