Home> Retail>  Edgebanding Application

Four Easy Steps

Edgebanding Instructions - Prepare Surface

Iron-on Edgebanding

  • Surface must be clean and dry
  • Fill any large holes
  • Sand rough spots
  • Remove sawdust
  • Cut edgebanding 1/2" longer than surface to be covered
RetailApplyVenrEdgV4_17.gif

Peel 'N Stick Edgebanding

  • Surface must be smooth, clean, dry and free of oil or dust. A sealed surface is recommended.
  • Fill any large holes
  • Sand rough spots
  • Remove dust and oil residue
  • Cut edgebanding 1/2" longer than surface to be covered
RetailApplyVenrEdgV4_20.png

Edgebanding Instructions - Apply Edgebanding

Iron-on

  • Preheat iron on “Cotton” setting
  • Position edgebanding
  • Slowly press iron over length of edgebanding
  • Check to see if glue is melting

NOTE: Use kraft paper or aluminum foil to protect iron bottom

Peel 'N Stick

  • Peel back release paper 2-4"
  • Position edgebanding
  • Press lightly into place
  • Gradually remove remaining release paper with one hand, while pressing edging into place with fingers, as shown

RetailApplyVenrEdgV4_29.gif

RetailApplyVenrEdgV4_31.gif

Edgebanding Instructions - Bonding

Iron-on

  • While still hot, press edging down firmly with wood block, roller or non-metallic blade
  • Mistake? Simply reheat and reapply

Peel 'N Stick

  • Press edgebanding down firmly using a wood block, roller or non-metallic blade
RetailApplyVenrEdgV4_40.gif

Edgebanding Instructions - Trim and Finish

Iron-on

  • Allow edgebanding to cool completely
  • Trim edge flush with the BAND-IT Edge Trimmer, a utility knife or file
  • If desired, sand smooth and finish per manufacturer’s directions
  • Do not sand melamine edgebanding

Peel 'N Stick

  • Allow edging to set a least 30 minutes before trimming
  • Trim edge flush with the BAND-IT Edge Trimmer, a utility knife or file
  • If desired, sand smooth and finish per the manufacturer’s directions
RetailApplyVenrEdgV4_42.gif

Available at Home Centers and Hardware Stores Everywhere!